This is driving me nuts! System is a 3825, 12.4(9)T1, CME 4.0. My innternational dial-peer is as follows:
dial-peer voice 9011 pots
description International dialing
As soon as I hit the "0" in "90" it gives me a fast busy. If I change the destination pattern to 011T and remove the prefix, it works just fine. Here is a 'debug voip dialpeer' output when the pattern in 9011T:
Nov 21 17:17:26.738: //-1/xxxxxxxxxxxx/DPM/dpAssociateIncomingPeerCore:
Calling Number=2306, Called Number=, Voice-Interface=0x68AC5E78,
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...