I have a quick question regarding 911. We have two PRI's at our home office and a couple of POTS on FXO. For some reason we were setup for 911 to go out POTS instead of the PRI. The only problem with this is, if 911 is dialed and then disconnected, 911 calls back and gets the front desk and not the phone that called. So then the front desk is stuck trying to figure out which of the 200 emloyees in that building called 911. My questions:
1. Why can't 911 go over the PRI so that caller ID is the DID that actually called 911.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.