Help me please, cant perform voice/video call form CME to CUCM over sip(call as if is established but after two sec of silence the call is droped)
Logs from CME is attached.
Thanks in advance
voice service voip no ip address trusted authenticate allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to sip redirect ip2ip fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none h323 call start slow sip registrar server expires max 600 min 60 asymmetric payload full ! voice class media 1 ! voice class codec 1 codec preference 1 g711ulaw codec preference 2 g711alaw codec preference 3 g729r8 ! voice class h323 1 call start fast
voice register global mode cme source-address 192.168.4.192 port 5060 bandwidth video tias-modifier 500000 negotiate end-to-end max-dn 5 max-pool 5 load 9951 sip9951.9-2-3-27 authenticate register authenticate realm all timezone 32 time-format 24 date-format D/M/Y tftp-path flash: file text create profile sync 0004100543778428 network-locale RU user-locale RU camera video
voice register dn 1 number 85709 allow watch name SMIRNOV D.B. no-reg label SMIRNOV D.B. mwi
voice register pool 1 id mac 64D9.89C3.C654 type 9951 number 1 dn 1 dtmf-relay rtp-nte username cisco password cisco codec g711ulaw no vad camera video
dial-peer voice 81 voip translation-profile outgoing TRANSLATION1 destination-pattern 02481 session protocol sipv2 session target ipv4:172.16.152.254 session transport udp incoming called-number 85709 voice-class media 1 dtmf-relay rtp-nte codec g711ulaw no vad
Voice call from cme to cucm over sip trunk is now ok(i have to correct CSS on inbound SIP trunk on CUCM), but video is not ok.
Attached new log to original post : dubug ccsip all
Cisco Unified CME 8.6 supports local SIP-video-to-SIP-video calls and SIP-video-to-SCCP-CUVA-video calls on Cisco Unified IP Phones 8961, 9951, and 9971 on the line side. On the trunk side, SIP video call is only supported with SIP trunk. H323 trunk is not supported for video calls on Cisco Unified IP Phones 9951 and 9971.
The media path for SIP video call is flow through and media flow-around is not supported for SIP line in Cisco Unified CME.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...