Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

9951 video call

I cannot initiate a video call with a 9951. The 9951 can display video if the remote side such as a CUPC soft phone initiates a video call but there is no soft key or programmable feature button to initiate a video call. I have loaded 9.0.3 sip-9951 same issue. I have enabled video globally with the enterprise defaults and at the device level.

thanks,

Chris

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: 9951 video call

Hi Chris,

Have you verified that all of your 9951 phones are at the 9.0.3 firmware level?  I have seen cases where this could cause problems.

--Matt

2 REPLIES
Cisco Employee

Re: 9951 video call

Hi Chris,

Have you verified that all of your 9951 phones are at the 9.0.3 firmware level?  I have seen cases where this could cause problems.

--Matt

New Member

Re: 9951 video call

The issue was the firmware the phone some of the phones were on 9.0.1 and others 9.0.2 once we loaded 9.0.3 the issue resolved.

651
Views
0
Helpful
2
Replies
CreatePlease login to create content