Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

9971 can not power camera when it registers on CUCME.

How do you deal with this problem?

It works well after I disabled 'power negotiation' when I use CUCM.

But I didn't find any commend from CUCME.

3 REPLIES

Hi can you share with us the

Hi

 

can you share with us the below output from Cisco switch port which is connected to 9971?.

Switch# show power inline gigabitethernet 2/10 detail | begin LLDP

switch# show power inline gigabitethernet 2/10

 

Thanks

please rate all useful inormation

New Member

 The switch doesn't support

 

The switch doesn't support POE. I use one device power all ip phones.

HelloThe only bug CSCtf09186

Hello

The only bug CSCtf09186 with some 802.3af switches, which results in the Cisco Unified IP Phone 9951 and 9971 unable to negotiate for the additional power required to operate the IP phone's camera.For your case if you use power injector or other device , you shouldn't get any issues. Can you disable "no cdp-enable"  and "no lldp tlv-select power-management" under the interface on the switch  which connected to your IP phone and test?.

 

Thanks

please rate all useful information

 

48
Views
0
Helpful
3
Replies
CreatePlease to create content