I would like to verify that my feature control policy file is enabling all possible/available Softkey features on my 9971 phones.
I'd really appreciate if someone, with an operational 9971 phone, could verify the content of my attached Feature Policy file (filename as defined in the 9971 phone SEP.cnf.xml configuration file under <featurePolicyFile> tag) against their Feature Policy file.
The CUCM 8.6 Admin Guide describes the following feature policies. Ideally I like to know how these translate to the XML seetings/values stored in the FP file.
Feature Control Policy Default Values
Table 79-2 lists the features, default value, and associated softkeys for feature control policies.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...