Got these phones running with CUCM 184.108.40.20600-24. I have configured two lines on the phone. Somehow it is displaying incorrect settings as can be seen from the attached phone photo's. The only settings configured on CUCM for both lines are:
Directory Number Information
Line 1 on DeviceXXXXXXXXX
- Line Text Label
- External Phone Number Mask
So I am not too sure where it is getting the Display information when using Line 2. ANy ideas?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...