AAR settings

[iptuser55]

I`ve configured AAR so that phone A has been allocated AAR GRP A, Phone B AAR Group B

Phone A MASK 441615551000 AAR Group A, Location A, AAR CSS full access

Phone B MASK 12125551000 AAR Group B, Location B, AAR CSS full access

To dial Phone B from A I dial Telco 90012125551000 so due to this I have created an AAR group B with 900 in the Dial prefix to A

Testing

I modified the Location setting of B to 1KBP so to force AAR in place but when I make the call I get "Call can not take place ....." Is it the location B which is Allocated to B or do I reduce A ?

The only other part is that I use site codes to call A to B but with AAR if the call fails due to BW then it replaces the site code with the Mask ?

Any Idea`s

[Jaime Valencia]

have you enabled AAR thru the parameters?

does the GW is also part of the AAR group?

the number that AAR will dial is going to be the AAR prefix + external phone number mask.

that number needs to be routable thru the PSTN

HTH

javalenc

[iptuser55]

Thanks for the reply, The GW has the same AAR group as Phone A i.e. it inserts 900 to the external mask- same as the phone. AAR is set to true as well