When we try and use the abbreviated dial feature on the 7937 conference
phone we are getting strange results as far as what the phone is dialing. For example
under telephoney service we have directory entries for the end users to dial.
directory entry 49 817805551234 name John Doe
directory entry 50 815085559876 name Jane Doe
directory entry 51 84035558765 name Sam Doe
directory entry 52 817805557654 name Dave Doe
When we press 49 and then hit AbbrDial on the 7937 phone the phone tries to dial
When we press 52 and then hit AbbrDial on the 7937 phone the phone tries to dial
For some reason the 7937 phone is injecting the entry number in the dialed digits.
From the 7942 and 7962 phone we are able to successfully use the AbbrDial softkey.
I have tried different firmware on the 7937 phones thinking this might be related to that but i get the same results.
I have also read through the administration guide for CME and I did see the following but I find it hard to believe that AbbrDial is only supported on the models listed. Also it works on my other phones which are not listed 7941, 7942, 7961, 7962.
I checked the notes from my previous TAC case. According to the TAC engineer I worked with abbrdial is not a function which is supported on the 7937 phones. I didn't spend much time after that trying to get it to work.
It has been a while since i have been to this client - but If i remember correctly we created 4 digits num-exp on the CME router which would translate the digits to the numbers we wanted. For instance
num-exp 4444 918005532447
so that if someone dialed 4444 the router would translate the number and that matches a dial-peer which sends the call out the PSTN. This worked for what they were trying to accomplish.
Also this client ended up migrating from CME to business edition CUCM so we started using 4 digits translation patterns.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...