Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Abnormal Behaviour,let you see

hello,

i have CCM connected to Ericsson PBX via VIC-2BRI through a gateway 2811, the problem is for some calls when i dial the number, it takes much time to display in the ip phone Connect message, and the ring back does not yet here, and after few seconds (9 sec), we hear the ring back .

Resume: the Connect message is displayed before the called person goes off-hook.

3 REPLIES
Silver

Re: Abnormal Behaviour,let you see

could you attach your config, maybe something missing in your dial-peers?

New Member

Re: Abnormal Behaviour,let you see

hello,

IN attachement, you will find the config of the gateway.

B.R

Silver

Re: Abnormal Behaviour,let you see

Hi, try adding -tone ringback alert-no-PI to one of your dial-peers to test.

This document may be of some help also:

http://www.cisco.com/warp/public/788/voip/ringback.html

97
Views
0
Helpful
3
Replies