Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

about networkd-clock-participate

Greeting, i need help with configuration about network-clock. Look my scenario.

-------------------------------------------

1 2851 with 2 E1

E1(A) Used only for incoming calls

E1(B) Used for incoming and outgoing calls

-------------------------------------------

E1(A)

controller E1 0/0/0

framing NO-CRC4

ds0-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani

cas-custom 0

country brazil

metering

debounce-time 10

answer-signal group-b 1

dnis-digits min 1 max 4

E1(B)

controller E1 0/1/0

framing NO-CRC4

pri-group timeslots 1-31

####

network-clock-participate wic 0

network-clock-participate wic 1

network-clock-select 1 E1 0/1/0

####

But the Slip Secs and Errored Secs is increasing in Wic 0

if I insert the command network-clock-select 2 E1 0/0/0 the errors increase.

I read about network-clock-participate, i try remove it from Wic 0. but appear this message.

VGCOOMEX001(config)#no network-clock-participate wic 0

%At least one ds0-group was configured already for E1 0/0/0.

Please remove it before changing timing mode.

Anyone can help me ?

3 REPLIES
Hall of Fame Super Gold

Re: about networkd-clock-participate

E1 0/0/0 goes to PSTN.

E1 0/1/0 goes to what ?

Community Member

Re: about networkd-clock-participate

PSTN too .... but E1(a)[[3037XXXX]] is only for incoming calls

E1(b)[[3014XXXX]] is used for incoming and outgoing

Hall of Fame Super Gold

Re: about networkd-clock-participate

Different telcos ?

If so, chances are you will never eliminate slips off one interface and will have to live with that. Generally they are a problem for fax only.

318
Views
0
Helpful
3
Replies
CreatePlease to create content