Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

Access ATA Configuration Page

CUCM 6.1.1.3101-1 & ATA 186(What I believe is the firmware load): ATA030203SCCP051201A

I try to access the configuration page via IE. I type IPAddress/dev and the page does not load.

I pinged our vendor, but have nothing of value back from him.

BTW, I'm trying to change the ring cadence so I can use the ATA with our VC equipment for audio in. They have a 'clearone' system and they are stating that the ATA is not providing 'POTS ringing.' They see it ringing, but their device can not answer.

I need to get to the configuration page. I've done this at my last job, but was on CM 3.3.

Any ideas?

Thank you in advance,

Liz

1 REPLY
Bronze

Re: Access ATA Configuration Page

I figured out that I can't access the /dev page with CUCM 6. I'll have to make any changes to the txt file, convert and upload via TFTP.

I wish it was easier like before though. The GUI interface on the /dev page was easier.

255
Views
0
Helpful
1
Replies
CreatePlease to create content