We have 4402 wireless Controller with 1132 AP, in switch we need to configure access vlan or trunk for Acees point, when I try acess point as trunk vlan, it is not get registered with controller. Please light me about switch configuration on access point with controller.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.