Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Ad-hoc conference. Cisco Video Conference Bridge(IPVC-35xx)

Hi all,

Can i use the Cisco Video Conference Bridge(IPVC-35xx) (Meeting Place) to use an ad-hoc audio conference?

I successfully registered the conference bridge to the CUCM . But the conference fails . Below the scenario:

        -Phone A (Device pool A , region A ) calls phone B ( same DP and region)

         -Phone B begins a conference with phone C (Device pool C , region C) : remote site with SRST GW.

        - Conference Fails

         *Codec between region A and Region C is G.729.

I don't have DSP ressources on my SRST GW to configure DSPfarm etc... and i know that the software conference bridge are not working for a non G.711 calls.

I though that the Cisco Video Conference Bridge(IPVC-35xx) will resolve this issue. am i wrong ?

Thank you in advance

Everyone's tags (4)
3 REPLIES
Cisco Employee

Ad-hoc conference. Cisco Video Conference Bridge(IPVC-35xx)

New Member

Ad-hoc conference. Cisco Video Conference Bridge(IPVC-35xx)

Thank you for your answer.

We have a Meeting place express installation . No hardware MCU. We already have a sip trunk between CUCM and Meeting place.

Regards

Cisco Employee

Ad-hoc conference. Cisco Video Conference Bridge(IPVC-35xx)

818
Views
0
Helpful
3
Replies
CreatePlease to create content