Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Add DID numbers

With CCM 4.1 and a Cisco 2811 Router, I'm trying to add another set of DID numbers we just purchased. Our existing phone numbers are NPA-NXX-5300. We have another set of numbers, NPA-NXX-5500. Where do I go to setup this new block of DIDs?

Thanks

3 REPLIES
Cisco Employee

Re: Add DID numbers

if they're coming thru the PRIs you have simply configure the DNs in CCM.

if new PRIs configure the GWs, and inbound CSS, then DNs in CCM

If H323 add the new dial-peers for it, otherwise if MGCP just configure inbound CSS

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Add DID numbers

Well, lets say the DID numbers were on a different prefix but on the same PRI. Our extension numbers are the last four numbers of the DID. How does CCM distinguish between the DIDs on the different prefixes?

Re: Add DID numbers

It doesn't. Not unless you create 7 digit DN's or seperate partitions. Do your number ranges overlap? Typically, the PSTN provider will only pass the last 4 digits to you (although you can request as many as you want), in which case, the CCM and VG would never know the different between a DID of 555-1234 and 666-1234, because it will only see the '1234'.

149
Views
8
Helpful
3
Replies