Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Add different new DID blocks in call manager

I have did blocks 6828 7000 to 6828 7699 running in call manager and use two isdn-30 lines in 3745 routers to ptt for incoming/outgoing call. I will add new did blocks 6829-3100 to 6829-3199 in call manager and voice router. any suggestion or reference to customzie the voice router to support two set of did blocks in call manager. I am useing h323 to ptt.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Add different new DID blocks in call manager

There is nothing special you need to do, simply add new dialpeer(s) matching this range and point to CCM. The dial-peer destination-pattern will be based on however many significant digits the telco is sending to you, so for example assuming that telco is sending you 8 digits, then create the following dial-peer:

dial-peer voice 100 voip

destination-pattern 682931..

session-target ipv4:

codec <>

no vad

HTH, please rate all helpful posts!

Chris

1 REPLY
Hall of Fame Super Silver

Re: Add different new DID blocks in call manager

There is nothing special you need to do, simply add new dialpeer(s) matching this range and point to CCM. The dial-peer destination-pattern will be based on however many significant digits the telco is sending to you, so for example assuming that telco is sending you 8 digits, then create the following dial-peer:

dial-peer voice 100 voip

destination-pattern 682931..

session-target ipv4:

codec <>

no vad

HTH, please rate all helpful posts!

Chris

503
Views
0
Helpful
1
Replies
CreatePlease to create content