cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
455
Views
0
Helpful
3
Replies

Add digits to inbound digits before sending to Call Manager

MICHAEL BURNS
Level 1
Level 1

My current provider sends 10 digits and we are migrating to a new provider that will only send 7 digits.  I want to do make the migration easier by adjusting the dial peer in the gateway so that it sends the same digits to the Call Manager that are currently being sent.  How can I prepend our area code to the inbound digits?

dial-peer voice 2500 voip

description AT&T Test

preference 1

destination-pattern 994300[34]

session target ipv4:10.0.2.111

dtmf-relay h245-alphanumeric h245-signal

codec g711ulaw

no vad

I have adjusted the destination-pattern to reflect the new 7 digits, but how can I add our area code before it is sent to Call Manager?

1 Accepted Solution

Accepted Solutions

George Thomas
Level 10
Level 10

Hi Michael,

You will have to use a translation rules  to prefix the area code on the voip dial-peers.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a0080325e8e.shtml

Please rate useful posts.

Please rate useful posts.

View solution in original post

3 Replies 3

George Thomas
Level 10
Level 10

Hi Michael,

You will have to use a translation rules  to prefix the area code on the voip dial-peers.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a0080325e8e.shtml

Please rate useful posts.

Please rate useful posts.

Thanks for the help.  BTW, how do you rate answers?  I must be missing something.

Looks like you got it right. Thanks for the rating. Good luck!

Please rate useful posts.

Please rate useful posts.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: