Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Add digits to inbound digits before sending to Call Manager

My current provider sends 10 digits and we are migrating to a new provider that will only send 7 digits.  I want to do make the migration easier by adjusting the dial peer in the gateway so that it sends the same digits to the Call Manager that are currently being sent.  How can I prepend our area code to the inbound digits?

dial-peer voice 2500 voip

description AT&T Test

preference 1

destination-pattern 994300[34]

session target ipv4:10.0.2.111

dtmf-relay h245-alphanumeric h245-signal

codec g711ulaw

no vad

I have adjusted the destination-pattern to reflect the new 7 digits, but how can I add our area code before it is sent to Call Manager?

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions

Add digits to inbound digits before sending to Call Manager

Hi Michael,

You will have to use a translation rules  to prefix the area code on the voip dial-peers.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a0080325e8e.shtml

Please rate useful posts.

Please rate useful posts.
3 REPLIES

Add digits to inbound digits before sending to Call Manager

Hi Michael,

You will have to use a translation rules  to prefix the area code on the voip dial-peers.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a0080325e8e.shtml

Please rate useful posts.

Please rate useful posts.
Community Member

Add digits to inbound digits before sending to Call Manager

Thanks for the help.  BTW, how do you rate answers?  I must be missing something.

Add digits to inbound digits before sending to Call Manager

Looks like you got it right. Thanks for the rating. Good luck!

Please rate useful posts.

Please rate useful posts.
225
Views
0
Helpful
3
Replies
CreatePlease to create content