I am trying to add a new IP range to my voice VLAN. I have it to where it works on the local network, but when the system makes a call outside I can here the person but they can't hear me. I am not sure where to check to see what the problem is. I see some ACL for the orginal VOice VLAN on my 3825. I am thinking I need to add the new range to that and create a route for it also. Any help would be greatly appreciated.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.