Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Add Port to h323 Dial-peer

Trying to add a new bri port to an existing h323 gw, which has 2 bri's already configured. When creating dial peer, I cannot select new bri port. do I need to reset the h323 in order to see the new port in dialpeer config? thanks

4 REPLIES
Hall of Fame Super Silver

Re: Add Port to h323 Dial-peer

First of all is the card even detected? Does it show under "sh diag", second of all is there a voice-port in the configuration?

Chris

New Member

Re: Add Port to h323 Dial-peer

Shows up under show diag, and sho run.

voice port config is missing, cannot add 0/0/0

interface BRI0/0/0

no ip address

encapsulation hdlc

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

isdn static-tei 0

Bronze

Re: Add Port to h323 Dial-peer

You may have been probably forgotten "isdn layer-1 emulate" and "isdn protocol-emulate network" commands.

Hope the following link helps...

http://www.cisco.com/en/US/docs/ios/12_1/12_1xi/feature/guide/dt_brint.html

And I surprised to see HDLC encapsulation on the interface.

Regards..

-Ashok.

With best regards... Ashok ----------- Pls kindly rate if helpful or answered your question.
New Member

Re: Add Port to h323 Dial-peer

that looks like a global command. 2 BRI ports are already working. Is this an interface command? Also, tried removing the hdlc encap, keeps coming back.

110
Views
0
Helpful
4
Replies