Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

adding incoming numbers

Hi All,

We have a Cisco 2801 Router with a 15 Channel ISDN and an internal IP Telephone System. Our Phone Service Provider has already given us a 100 range of numbers attached to the 15 Channels, but is going to add 2 additional individual numbers completely outside of this range.

I need to know that our router will accept calls for these numbers and pass them to our IP telephone server to determine which extension is to receive the call.

Currently I see two areas that refer to our 100 range as it is now. Would I need to add these 2 individual numbers in these areas as well?

translation-rule 22

Rule 1 02811780 811780

and the following I believe is only for outgoing calls which does not matter, I do not need calls to me made outgoing via these 2 additional numbers.

dial-peer voice 3 voip

translation-profile outgoing calling

destination-pattern 811780..

voice-class codec 1

max-redirects 10

session protocol sipv2

session target sip-server

dtmf-relay rtp-nte

no vad

If I have not made any sense, please ask me any questions you may have.

Thankyou in advance for your help.

2 REPLIES
Silver

Re: adding incoming numbers

Called number (DNIS) with incoming called-number

First, the router or gateway attempts to match the called number of the call set-up request with the configured incoming called-number of each dial-peer. Since call setups always include DNIS information, it is recommended to use the incoming called-number command for inbound dial peer matching. This attribute has matching priority over answer-address and destination-pattern.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

New Member

Re: adding incoming numbers

Yeah we already had that set up. I just did not include it in my post.

dial-peer voice 1 pots

voice cut-through alert

description Incoming ISDN Dialpeer

incoming called-number .

direct-inward-dial

port 0/1/0:15

!

dial-peer voice 2 pots

description Outbound DialPeer

destination-pattern 0T

port 0/1/0:15

!

dial-peer voice 3 voip

translation-profile outgoing calling

destination-pattern 866780..

voice-class codec 1

max-redirects 10

session protocol sipv2

session target sip-server

dtmf-relay rtp-nte

no vad

!

dial-peer voice 4 voip

translation-profile outgoing calling

destination-pattern A800AT

voice-class codec 1

max-redirects 10

session protocol sipv2

session target sip-server

dtmf-relay rtp-nte

no vad

!

dial-peer voice 5 voip

translation-profile outgoing calling

destination-pattern .

voice-class codec 1

max-redirects 10

session protocol sipv2

session target sip-server

dtmf-relay rtp-nte

no vad

!

I'm still not sure what to do here though. I think I might have a translation issue.

98
Views
0
Helpful
2
Replies
CreatePlease to create content