Adhoc conferencing giving busy tone when using non-default region
This strange issue is occuring on call manager 9.1. When the default device pool is used on the phones they are able to adhoc conference each other. When a different device pool is used and a new region is created but has the same settings as the default region it is still giving the busy tone.
Adhoc conferencing giving busy tone when using non-default regio
Default inter-region Codec unless you changed it is G.729. Software conference bridge in CallManager doesn't support G.729 so a transcoder or hardware conference bridge must be used. Your other option would be to just change the max audio bit rate between the Default region and the new region to 64kbps.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...