While using Cisco AS53XX/AS54XX (or any other similar GW), I need assistance to adjust/alter the ISDN messages back to the switch in case the internet connection to the GW is going down.
The GW is connected with E1 ISDN PRI circuits to a Nortel International switch. The flow of the traffic is from the Nortel switch to the GW to complete the calls through a VOIP dial-peer to a termination carrier. In such case when the Internet connection to the GW is down, the ISDN messages back to the switch are "timer expiry" messages which do not allow to the switch to keep hunting the calls to the second route. Instead the calls are dropped and the caller hears Fast-Busy.
Is there a way to adjust/change such messages, from the GW to the ISDN switch, to a "congestion" type messages which will allow the switch to complete the calls to second route?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.