After CUCM 6.1.3 Upgrade 7912 phones not upgrading the respective firmwares
I upgraded a CCM 4.1.3 to CUCM 6.1.3,Upgrade was successful all the phones except 7912 take the new loads.
I have a problem with 7912 phones which is getting registered with their old firmwares,but not the new firmware listed in CUCM 6.1.3(In device defaults the load is pointed to the correct Device Pool).Pls advice.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...