we have a customer with cisco express and unity express using an AIM-CUE module.
we are planning on upgrading the software from version 2.3 to 3.1 i think it is. (one of the latest ones).
am i right in thinking we could get a spare aim-cue with the latest code on it and take a backup of the config/voicemail and then swap the modules and then once swapped then just restore the voicemails , configs etc..
only done it once before and was a bit of a pain to be honest. i am going from release 2.1 to a fairly new release and said you need to do a clean install it says. does a clean install mean you lose the config and voicemails etc..?
Also, does the unity express software itself sit on the AIM-CUE then?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.