Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AIM-CUE with CUCM 6.x

Anybody having issue with registration of AIM-CUE 3.2.1 with CUCM 6.x? I am unable to get AIM module to register. All CTI ports and CTI route point showing as "unknown" in CUCM. Any debugs I could run? Licences are OK.

1 REPLY
Bronze

Re: AIM-CUE with CUCM 6.x

Hi, check if the CTI RP and CTI Ports are associated with the JTAPI user that CUE uses in order to log into the CCM and take control of the CTI Ports.

Be sure that the JTAPI user and password created in the CCM are the same that the JTAPI user and password that you created in the CUE.

Also check this good document: http://www.cisco.com/en/US/products/sw/voicesw/ps5520/products_configuration_example09186a0080289ef0.shtml

Hope this help

David

152
Views
0
Helpful
1
Replies