Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AIM Module Detection Issue on 2801

I installed an AIM-CUE module on my 2801. 

When I powered the router with the cover off the router, the light on the AIM module illuminated.

The IOS I am using is c2801-ipvoicek9-mz.124-15.xy5.bin

The command I used to detect the AIM module was show inventory.  I was expecting it to show "AIM Service Engine" somewhere.

I also unplugged the router and tried both AIM Slot 0 and AIM Slot 1 positions on the 2801 board.  Neither seem to give me any indication that the AIM Module is being detected.

Is there anyway to do a diagnostics test on the AIM Module?

Am I missing something?

Any help would be greatly appreciated.

Thank you kindly.

1 ACCEPTED SOLUTION

Accepted Solutions

AIM Module Detection Issue on 2801

hi Edward,

According to compatibility matrix   the minimum IOS requirement you should be on for 2801 is....  

12.3(8)T4 - AIM CUE

12.4(22)YB4, 12.4(24)T - AIM2-CUE

http://www.cisco.com/en/US/docs/voice_ip_comm/unity_exp/compatibility/cuecomp.htm

Hope this helps!

Thanks,

Karthik

2 REPLIES

AIM Module Detection Issue on 2801

hi Edward,

According to compatibility matrix   the minimum IOS requirement you should be on for 2801 is....  

12.3(8)T4 - AIM CUE

12.4(22)YB4, 12.4(24)T - AIM2-CUE

http://www.cisco.com/en/US/docs/voice_ip_comm/unity_exp/compatibility/cuecomp.htm

Hope this helps!

Thanks,

Karthik

New Member

AIM Module Detection Issue on 2801

Thank you for your response. 

I finally figured out what the problem was.

I had to tighten the AIM-CUE mounting screws extra hard for it to be detectable. 

It is working fine now, and thank you for your help.

477
Views
0
Helpful
2
Replies