Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

tom
New Member

All circuits are busy

My client is having intermittent problems their CM 4.2.3. I think it is a GATEWAY/PRI (2851’s) related. I need some help trouble shooting advice from a CM Gateway standpoint.

There is nothing to obvious in the system logs. When callers call from the outside they get an AT&T message saying (All circuits are busy). Is there anything obvious I can check? This only happened for about an hour yesterday and today from 8:00AM to 9:00AM., and then the (All circuits are busy) message for AT&T disappears. From the logs, the PRI’s are under utilized and never get close to capacity.

Thanks Tom

2 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

Re: All circuits are busy

If you have the CUCM traces from that time you can use VLT or triple combo to look at the ISDN messages and the disconnect side and reason.

This really should have been looked into at the time and with debugs in the GWs.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Hall of Fame Super Gold

Re: All circuits are busy

When in doubt, check show isdn active. If you see any stuck call, reload is the safest option.

3 REPLIES
Cisco Employee

Re: All circuits are busy

If you have the CUCM traces from that time you can use VLT or triple combo to look at the ISDN messages and the disconnect side and reason.

This really should have been looked into at the time and with debugs in the GWs.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
tom
New Member

Re: All circuits are busy

Java:

I did some additional testing on the 2851 gateway. sh voice dsp active and can see the calls populating.

It has to be our teleco. I am opening a ticket with them. Wish me luck.

Thanks Tom     

Hall of Fame Super Gold

Re: All circuits are busy

When in doubt, check show isdn active. If you see any stuck call, reload is the safest option.

784
Views
0
Helpful
3
Replies
CreatePlease to create content