I have CUCM 7.1.5 with a lot of CIPCs connected to it. Each CIPC has 3 directory numbers (for example 107, 207, 307) and incoming call can arrive on any of these lines.
I have managed to allow only one call for each line by setting Busy Trigger = 1 in settings of each directory number.
What I want to do, is to allow only one call for the whole device (for all lines together). That is, when phone is already answered call from line 107, then if call is arriving on 207 or 307, CUCM should put 'busy' signal to new caller.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...