We use the Real Time Monitoring Tool (RTMT) to monitor our E1 Circuits (CM 4). We find that RTMT only gives a "used channels" figure for the ENTIRE router, as opposed to a figure for each E1 Circuit.
As an example, suppose we have four 30 channel E1 circuits on a router. RTMT gives us a utilization figure out of 120, instead of giving us four circuit utilization figures, each out of 30.
Is there a way within the RTMT to monitor channel usage on individual E1 circuits? If not, is there another tool (Either free or commercially available) that allows us to monitor individual E1 channel usage?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.