Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Am I OK for voice if I am running ENTERPRISE BASIC IOS ?

If I want to run VoIP on my 2610 routers (running XM image c2600-j1s3-mz.123-16.bin) do you know whether I can setup the FXO voice card and make this work if I have the ENTERPRISE BASIC image ?

Someone told me that I should run the IP Plus IOS. However, the Cisco Feature software navigator and the (config)#? commands below seem to indicate that the ENTERPRISE BASIC I am running does support voice. Please confirm whether I will be OK with the ENTERPRISE BASIC image, including when installing the appropriate voice cards onto my C2610.

Thanks much !

RouterB(config)#voice ?

call enable to send alert instead of progress.

class Control parameters class

disc-pi-incoming-on disconn with PI from incoming leg is maintained

dnis-map Create or add to a dnis-map

dsp DSP functions

enum-match-table enum match table entry

hpi Host port interface

hunt Dialpeer hunt conditions.

rtp enable to open RTP in both directions.

service Global packet telephony service commands

source-group Source Group configuration commands

translation-profile Translation profile configuration commands

translation-rule Translation Rule configuration commands

vad-time Voice activity detection hangover period

RouterB(config)#voice

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Am I OK for voice if I am running ENTERPRISE BASIC IOS ?

Outputs from Software Advisor

2 REPLIES
Silver

Re: Am I OK for voice if I am running ENTERPRISE BASIC IOS ?

Software Advisor at this link would be your best tool to answer this.

http://www.cisco.com/kobayashi/support/tac/tools.shtml

I checked that out and yes Enterprise Basic would support your FXO card but that depends on the FXO card model.

VIC-2FXO ---> 12.3.16 Enterprise Basic would support. This is the IOS you mentioned above.

For other models, like VIC2-2FXO or VIC2-4FXO, you will need Enterprise Base feature set and a T train.

Please see attached outputs from Software Advisor.

Silver

Re: Am I OK for voice if I am running ENTERPRISE BASIC IOS ?

Outputs from Software Advisor

141
Views
0
Helpful
2
Replies
CreatePlease login to create content