Am I OK for voice if I am running ENTERPRISE BASIC IOS ?

[news2010a]

If I want to run VoIP on my 2610 routers (running XM image c2600-j1s3-mz.123-16.bin) do you know whether I can setup the FXO voice card and make this work if I have the ENTERPRISE BASIC image ?

Someone told me that I should run the IP Plus IOS. However, the Cisco Feature software navigator and the (config)#? commands below seem to indicate that the ENTERPRISE BASIC I am running does support voice. Please confirm whether I will be OK with the ENTERPRISE BASIC image, including when installing the appropriate voice cards onto my C2610.

Thanks much !

RouterB(config)#voice ?

call enable to send alert instead of progress.

class Control parameters class

disc-pi-incoming-on disconn with PI from incoming leg is maintained

dnis-map Create or add to a dnis-map

dsp DSP functions

enum-match-table enum match table entry

hpi Host port interface

hunt Dialpeer hunt conditions.

rtp enable to open RTP in both directions.

service Global packet telephony service commands

source-group Source Group configuration commands

translation-profile Translation profile configuration commands

translation-rule Translation Rule configuration commands

vad-time Voice activity detection hangover period

RouterB(config)#voice

[pbarman]

Software Advisor at this link would be your best tool to answer this.

http://www.cisco.com/kobayashi/support/tac/tools.shtml

I checked that out and yes Enterprise Basic would support your FXO card but that depends on the FXO card model.

VIC-2FXO ---> 12.3.16 Enterprise Basic would support. This is the IOS you mentioned above.

For other models, like VIC2-2FXO or VIC2-4FXO, you will need Enterprise Base feature set and a T train.

Please see attached outputs from Software Advisor.

[pbarman · Accepted solution]

Outputs from Software Advisor