We can't seem to get AMIS to work. It appears when installing the Voice Connector 12.x it installs under the context of the local system account. Had to change it to UnityMesgStoreSvc account and then grant that account Exchange Admin rights so it would start.
Created UAMIS account with ConfigMgr. Confirmed creation but when using Port status monitor and addressing a AMIS user we never see an AMIS message leave the Unity system. Cisco TAC can't seem to figure it out yet and it is a P2 case. Any suggestions would be warmly welcomed. -Paul
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...