Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Analog DID and 2901 calls fail.

I have a site that was recently converted from a TDM system using analog DID's. A Vwic 4 fxs/did was installed. The ports were set up as did, wink start. Calls do not seem to pass the digits across the dial peers or on the debuts. There is a dial peer with incoming number.

Normally with an analog did port you can use a test set to test dial numbers; however that fails.

Debugs show the call hitting the port, but flexdsprm-3-TDM connect fails to connect voice port to ESP channel.

Sent from Cisco Technical Support iPad App

1 REPLY
New Member

Re: Analog DID and 2901 calls fail.

Here is an update to the issue:

To clear the DSP errors, a reload of the gateway was preformed. This did not clear the issue. The FXS card was replaced, and the gateway reloaded.

There were bent pins on the trunk demarc causing a short on one DID trunk. The ports were removed and added back.

The issue is cleared and working now.

Sent from Cisco Technical Support iPad App

401
Views
0
Helpful
1
Replies
CreatePlease login to create content