Analog DID and 2901 calls fail.

[john boxold]

I have a site that was recently converted from a TDM system using analog DID's. A Vwic 4 fxs/did was installed. The ports were set up as did, wink start. Calls do not seem to pass the digits across the dial peers or on the debuts. There is a dial peer with incoming number.

Normally with an analog did port you can use a test set to test dial numbers; however that fails.

Debugs show the call hitting the port, but flexdsprm-3-TDM connect fails to connect voice port to ESP channel.

Sent from Cisco Technical Support iPad App

[john boxold]

Here is an update to the issue:

To clear the DSP errors, a reload of the gateway was preformed. This did not clear the issue. The FXS card was replaced, and the gateway reloaded.

There were bent pins on the trunk demarc causing a short on one DID trunk. The ports were removed and added back.

The issue is cleared and working now.

Sent from Cisco Technical Support iPad App