analog hookflash from VG224+CME over SIP trunk to CUCM - failed
I have the office with CUCM 7.1 and 2911 as h323 gateway to PSTN
I have the branch with CME with FXO cards to PSTN - and VG224 with analog phones
CUCM and CME interconnect with SIP trunk.
I can connect any phone from the office (Cisco sccp phone) and any phone from the branch without problem. the direction of call is not important. every direction works fine. and every method - PSTN or SIP trunk - works fine.
When I use PSTN connection I can forward a call from one branch analog phone to another branch analog phone using hookflash button.
When I use SIP trunk I cannot forward a call from one branch analog phone to another branch analog phone using hookflash button. Call is desconnecting after I press hookflash button.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...