* and then a 4 digit extension call manager will forward me to the users voicemail. This does not work work wth 5 digit ext
so some of our users have brought it to my attention that when they dial the voicemail shortcut *4443 it will work and transfer with no issue but if they do *58326 it says "I did not recognize that as a valid entry" then forwards out to the automated system.
You most likely have a CTI Route Point that is *XXXX that matches a * and 4 digits. The reason digits does work is your would need a CTI route Point that is *XXXXX that would send to 5 digits voice mail.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...