I have AS5350 connected to IP-network from one side and to PBX (ISDN) from other side. Then a user of PBX placing a call to the AS5350 it get an announcement but then user placing a call to some another numbers it geting ringback but it must also get an announcement. How can i solve the problem ?
Different components inside Cisco IOS software work together to enable remote clients to dial in and send packets. Figure 2 shows one Cisco AS5300 access server that is receiving calls from a remote office, branch office (ROBO); small office, home office (SOHO); and modem client.
Depending on your network scenario, you may encounter all of the components. For example, you might decide to create a virtual IP subnet by using a loopback interface. This step saves address space. Virtual subnets can exist inside devices that you advertise to your backbone. In turn, IP packets get relayed to remote PCs, which route back to the central site.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.