Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Any TAC engineer.Plz help

https://tools.cisco.com/bugsearch/bug/CSCtn81394

Symptom:

Fresh install, RU or system reboot fails with error "could not detect IMM Device"

Conditions:

On IBM's IMM based servers (7835/45-I3, 7816/25/28-I5) if a user manually disables in-band USB interface, then CUCM scripts cannot detect and configure hardware. This is a critical setting, its enabled by default, and is needed for CUCM scripts to work.

Workaround:

User should revert back manual changes to the in-band usb interface settings to default (enabled).

Plz help guys,how i can revert the integrated management module settings back to default :((((((((((((((((((((((((((((((((((((((((

2 REPLIES
Cisco Employee

Any TAC engineer.Plz help

Hi,

This should be something you check with IBM, but this migth help, please check Page 63:

http://pic.dhe.ibm.com/infocenter/sonasic/sonas1ic/topic/com.ibm.sonas.doc/imm_users_guide_60y1465.pdf

Regards, 

Tere. 

If you find this post helpful, please rate!

Regards, Tere. If you find this post helpful, please rate! :)
New Member

Any TAC engineer.Plz help

Thanks

281
Views
7
Helpful
2
Replies