Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Any way to modify inbound dial peer on CME?

I have a voice application I need to test. It needs to run on the inbound dial peer for a call that is destined to an FXS port on the CME.

I tried to make a voip dial peer with "incoming called-number ." but this does not work, instead CME uses the hidden dial-peers for the ephones, and those don't seem to be able to be modified.

So I would like to place a call from an ephone to an FXS port, and configure my voice application to run on the inbound leg, is this possible?

1 REPLY
New Member

Re: Any way to modify inbound dial peer on CME?

Replying to my own post:

Here is how it can be done:

!

voice translation-rule 2

rule 1 /1001/ /1002/

!

!

voice translation-profile 2

translate called 2

!

!

application

service myapplication flash://myapplication.tcl

!

dial-peer voice 200 pots

destination-pattern 1002

port 2/0

!

dial-peer voice 300 voip

translation-profile outgoing 2

destination-pattern 1001

session target ipv4:172.16.2.2 <------------- This is the CME's IP address

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

!

dial-peer voice 301 voip

service myapplication

incoming called-number 1002

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

123
Views
0
Helpful
1
Replies