Interested to know if anybody is running 7910G with CUCM 7.0. Any issues? 7910 shows compatible with CUCM 7.0 and i wanted to know if anyone is actually using them with 7.0 and if you are running into any challenges as i am trying to squeeze more ROI out of my old phones.
Thanks for your response currently i am doing a migration from ccm 3.2 to ucm 7.0 and the customer has a bunch of 7910! I checked out the 7910 matrix and 7.0 was not listed, but i check the default phone loads on 7.0 and there is a sccp load for it. So i labbed it and it seems to work well with other sccp and sip phones. i just wanted to know if anyone seen issues in productions. I am trying to detach the ccm migration from the phone upgrade with a really paranoid customer.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...