Anyone have a working config for FXO port to home Vonage box?
I have purchased (waiting for delivery) of an FXO card to populate into my 2621XM router. My desire is to connect it to the analog port of my vonage box and integrate my Vonage "public" phone number with my Call Manager phone system.
Anyone have a working config that they would like to share?
Re: Anyone have a working config for FXO port to home Vonage box
In CM, configure an H323 GW with router's address. In router, under voice port configure "connection plar XXX opx" where XXX is the extension where your calls have to go. You will also need voip DP with CM address and destination-pattern XXX, and a pots DP with destinatition pattern like 9T. That's all.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...