Recently upgraded to 6.1 and now our MOH through the PSTN. Internal calls IP to IP phone work fine for MOH. But through the CMM, multicast stream will not start up. We see it connecting to the stream 220.127.116.11, etc, but nothing is coming out but dead air.
Looks like the DMA tool changed the amount of Hops in the multicast. In our 4.2 config, we had defined 5 hops. After the DMA, it changed it to the default 2 hops. That screwed up multicast to/from the PSTN.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...