I'm tryin to setup a Linksys SPA2102 with CM, and it keeps getting rejected. I have tried creating a different phone security profile that uses digest authentication. I have created a user in CM to use for this device. I'm not sure what I am missing. Anyone used these before?
Linksys SPA2102 devices work perfectly with CallManager. Linksys SPA2102 is the ATA-188 replacement.
On the CallManager side: Create new 3d party basic SIP. Set owner user id and digest user id to existing ad user, for security profile set standard sip non-secure. Then associate device with user.
On the phone side: Domain/Realm and SIP Proxy set to IP address of CallManager. Display name may be anything. User name is an extension assigned to the phone. Authorization User set to username set as owner/digest user in CallManager. Password can be blank.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.