Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Applying codec on pots dial-peer

Is there a way to apply codec G-711 A-law on a pots dial peer on a h323 gateway?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Applying codec on pots dial-peer

There is way because isn't needed, codec is associated with voip so you set it there.

5 REPLIES
Hall of Fame Super Gold

Re: Applying codec on pots dial-peer

No, whne necessary you apply the desire compounding type (A-law or U-law) under voice port, and the desired codec under the voip DP where the call goes out.

New Member

Re: Applying codec on pots dial-peer

Paolo,

So there is absolutely no way it can be assigned to pots dial peer, it works only on voip dial peers?

Thanks,

Das.

Hall of Fame Super Gold

Re: Applying codec on pots dial-peer

There is way because isn't needed, codec is associated with voip so you set it there.

New Member

Re: Applying codec on pots dial-peer

thanks a lot Paolo, have a nice day.

Hall of Fame Super Gold

Re: Applying codec on pots dial-peer

Of course I meant "there is no way". Thank you for the nice rating, I hope it's understood that my answers are always a bit short because I try to get "to the juice" all the time.

1233
Views
5
Helpful
5
Replies