I am trying to use the local Route groups to make TEHO easier. The problem I am running into is that some area codes (863) for example, require a 1 for 10 digit dialing and some numbers dont. How do I get around this?
91.[2-9]xxxxxxxx ---> RG 211
Strip Predot, Prefix 9.
9.[2-9]XXXXXXXX ----> RG 211
Im only sending the 10 digits because our remote site users would normally dial 9.1.863 773 9323
That way when it hits the gateway it should only send 10 digits like normal for a local call. The problem is some area codes that are suppose to be local require a 1! So how do I get around this?
Call me and I can explain more if you dont understand. I'm using Local Route Groups for my 9.@ pattern and 7 digit local dialing where i dont have a site.
You need to use more specific route patterns for those NPAs that require 10-digit dialing.
You can attach the route patterns to a route list that uses Local Route Groups but this is not Tail End Hop Off (TEHO). TEHO would require you put the route patterns on a route list that chooses a site-specific route group. You could add the Local Route Group as a secondary route list member for redundancy however.
Generic national route pattern; attached to a route list that uses local route group-based routing: 9.1[2-9]XX[2-9]XXXXXX
10-digit dialing route pattern; attached to a route list that uses a site-specific route group: 9.863[2-9]XXXXXX
9.1863[2-9]XXXXXX [Use transforms to strip the 1]
(Don't forget to add the 11-digit equivalent for users at other sites who would have called this NPA using normal 11-digit dialing.)
You need to be more detail on your patterns. What mean by this is to find a phone book and look up the local calling prefixes. At this point you would include the area code and now the prefix in your pattern.. This way the the pattern that is the better match is choosen..
I was wondering, it seems if I make the call via a h323 Gateway Telco answers and says "You do not require a 1 to make this call" . But telco doesnt send an "Unallocated Number". I was thinking of routing it to a different RG on my Route list and stripping the one. We are using H323 with FXO.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...