AS5300 E1 card takes too long to dectect analog phone disconnect
I have a AS5300 conected to the PSTN and by the other hand connected to an Asterisk server with sip. When we make a call to a ISDN phone Number or Mobile phone Number the gateway detects quikly the disconnect, but when we make a call to analog phone number it take's around 30 seconds to detect the disconnect.
Re: AS5300 E1 card takes too long to dectect analog phone discon
But in ISDN case the disconnect message it's too quick why analog not? When you are talking between two analog phones and one disconnects the other one detects this disconnect inmediately. I'll tried to make some changes on voice-port but unlike FXO voice-port's i can't configure disconnect detection.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...