We have an AS5400XM that we are testing for deployment. One of the scenarios we are testing is to use a SIP phone registered to an asterik PBX which then sends/receives calls to/from the outside world through the AS5400. We have had success with dialing in, but are having an issue with dialing out. When we dial a local number, we get a standard busy signal. When we dial a long distance number we get a fast busy. We're not sure where the problem lies.
The following is an example of the output from dialing a local number (debugging isdn q931 and dial peer information):
984792: Dec 10 21:52:51: //-1/4B4C4D4E5354/DPM/dpMatchPeersMoreArg:
List of Matched Outgoing Dial-peer(s):
1: Dial-peer Tag=101
984793: Dec 10 21:52:51: ISDN Se7/0:1:23 Q931: pak_private_number: Invalid type/plan 0x0 0x1 may be overriden; sw-type 2
984794: Dec 10 21:52:51: ISDN Se7/0:1:23 Q931: Applying typeplan for sw-type 0x2 is 0x2 0x1, Calling num 6003
984795: Dec 10 21:52:51: ISDN Se7/0:1:23 Q931: Applying typeplan for sw-type 0x2 is 0x0 0x1, Called num 3875116
Thanks for the help. I seem to be getting closer to solving this. I am now able to get a call through using call simulation from the AS5400, however still get the "Unallocated (unassigned) number..." error in the Q931 debug information. Is this a possible configuration issue or should I be looking somewhere else?
g.hammond, I am trying to do the same thing using my AS5400 that you were doing. I was just wondering if you were able to get it working properly, and if so, would you be willing to share your configs on the AS5400 and the Asterisk side.
If so, please let me know. You can reach me here: psands @ phoenixdatacorporation .com
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...