I've setup AS5400 as voice gateway with 10 T1, and on the IP side it has VoIP dial-peer pointed to the IVR. when I call the number, call is setup and active for 50 seconds and then disconnected. But I don't hear any prompt from IVR. I am sure IVR is working fine. Also when I do "debug voip rtp" I see rtp packet transmitting back and forth between IVR and Gateway but no audio. any suggestion would be very appreciated.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.