Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Assigning analog ext's to pick group in CME

Hi, all. We're running CME 7.1 at a site where a couple of analog extensions are defined in the gateway since they are connected to an FXS card. Since it's a small office, all extensions on 7975 devices are in a single pick group.

I have not been able to discover a way of assigning this pick group to the analog extensions in the IOS. Is this possible?

If not, will it cause a conflict if I define them in CME, perhaps as park-slot extensions, so I can make the p/g assignment?

Or is there another work-around?

Thanks much! Steve

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Assigning analog ext's to pick group in CME

Configure the FXS ports in SCCP mode (refer to admin guide), you will be able to handle them as ephone and use all features.

Please remember to rate useful posts with the scrollbox below.

2 REPLIES
Hall of Fame Super Gold

Re: Assigning analog ext's to pick group in CME

Configure the FXS ports in SCCP mode (refer to admin guide), you will be able to handle them as ephone and use all features.

Please remember to rate useful posts with the scrollbox below.

New Member

Re: Assigning analog ext's to pick group in CME

Thanks much!

133
Views
0
Helpful
2
Replies